Sales & system design
We look at your equipment, count the grease points, and spec the right Lubecore system for how you run it.
- On-site equipment walkaround
- Single machines or full fleets
- Clear, written quotes
JD Nash · Sales · Press 1
Automatic lubrication systems · Texas
Every grease point. Every cycle. No climbing.
Lonestar Lubrication sells, installs, and services Lubecore automatic lubrication systems for trucks, trailers, and heavy equipment. Your machines get the right amount of grease while they work, and your crew stops chasing zerks with a grease gun.
Authorized Lubecore dealer · Proudly serving all of Texas
Why autolube
Grease a little, often, and automatically
Manual greasing happens when someone has time, and points that are hard to reach get skipped. An automatic system delivers small, measured shots to every point on a schedule while the machine runs.
- Pump & controllerHolds the grease and runs lube cycles on a timer, automatically.
- Injector blockSplits every cycle into measured shots, one for each point.
- Grease linesHoses run along the frame, boom, and stick, secured and protected.
- Lube pointsEvery pin and bearing gets grease while the machine works. This excavator has 11.
Less wear
Pins, bushings, and bearings stay lubricated between shifts, not just once a day or once a week.
Less downtime
Fewer worn components to replace, and no machine sitting idle while someone works through the grease points.
Safer crews
Operators and techs stop climbing on equipment and reaching into tight spots with a grease gun.
Less waste
The right amount goes to each point. No over-greasing, and less grease thrown on the ground.
What we do
From first quote to long-term service
One local team handles the whole job, so you know exactly who to call.
Installation
Professional installs on trucks, trailers, and heavy equipment, with lines routed and protected so they last.
- Pump, controller, and injector setup
- Lines routed and secured
- System tested before handoff
Justin Rizor · Installation & Service · Press 2
Service & repair
Keep existing systems running right, whether we installed them or not.
- Inspections and troubleshooting
- Broken lines and fittings replaced
- Grease and replacement parts
Justin Rizor · Installation & Service · Press 2
Who we work with
Built for equipment that works hard
If it has grease points and runs every day, an autolube system can take that job off your crew's list.
ConstructionWaste & recyclingTrucking & transportationAgricultureMunicipal fleetsMining & aggregatePorts & terminalsStationary equipment
- Pump & controllerMounted on the frame behind the cab, out of the way of the trailer.
- Injector blockMeters a measured shot of grease for every point.
- Grease linesRun along the frame rails to the steer and drive axles.
- Lube pointsKingpins, drag link, spring pins, slack adjusters, brake cams, and the fifth wheel.
Authorized Lubecore dealer
Proven systems, backed locally
Lubecore designs and builds automatic lubrication systems in Canada, along with the grease and parts that go with them. We bring that equipment to Texas and stand behind every install with local service.
Talk to us about your fleetHow it works
Getting a system on your equipment
Talk to us
Tell us what you run and how many units. A call or the form below is enough to start.
Equipment review
We look at your machines and identify every grease point the system should cover.
Quote & install
You get a written quote. Once approved, we schedule the install around your work.
Ongoing service
We check the system, refill grease, and fix anything that gets damaged on the job.
Contact
Talk to a real person
Call or email us directly, or send a request and we'll get back to you.
Email uslonestarlubrication@gmail.com
Sales & quotesJD NashCall and press 1
Installation & serviceJustin RizorCall and press 2